![]() Thanks.I figure I have 2 days before this overflows. There is a valve that is about 2' above the pit.I will post a picture when I can.does it look like the valve can be loosened to let water out and release the vapor lock, if that is it?īefore I put a pipe wrench to the bottom of the valve.I would like to know that it is threaded and not a glued joint if anyone knows. ![]() What is the best way to troubleshoot? The ejector pipe has no cleanout, and the closest cleanout is a foot upstream from the 2" pipe going into the 6" pipe. So can it be vapor lock only in the 2" pipe? A blockage? When I run a sink upstairs I can hear water trickling into the 6" pipe. The pipe goes to the joists, over to the perimeter and into the larger6" pipe to the sewer. in a two pipe application or can be used in single pipe as well using the included ejector delivering up to an 16 GPM. The 1 HP pump draws water from up to 70 Ft. This pump features a 20/40-PSI pressure switch for reliable water pressure. The vertical pipe that goes into the house sewer pipes seems full of water, again hard to tell.just tapped on it. Draw water from your well, lake, or stream with this Zoeller 1 HP pro convertible jet pump with ejector. I have unplugged the pump.I couldn't tell if the pump was trying to run since the pump is 6" under water.other than the hum. These sewage pump systems mount in a basin where waste collects from a drain pipe and theyre turned on and off by an attached switch or control panel. So there is water in the pit, the float switch (zoeller m211) is free to move.yet nothing. ![]() ![]() This is a roughed-in plumbing situation that has never been used other than the humidifier going into the floor drain.unfinished basement and bathroom.5 yr old house. The cover to the pit is off, and the pit is almost above the intake pipes. The pump is humming, but not pumping (no jokes plz :jester ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |